| |
 |
 |
 |
|
Clock Setup |
May 16, 2010 |
| Reviewer:
Dan Roos perfectionist at heart
from Redwood City, CA United States
|
|
This is the exact info for clock from AT in San Bruno, CA
First, you need to set up the clock.
Then, hit the HQI or ACT. BLUE or LED to set up the three sections individually.
After you have the clock set, All sections should be at OFF position as indicated by the arrow underneath the time shown.
Then, hit the section you need to set up, for example HQI, twice, then arrow will point at AUTO
Hit PROG, You will see ON shown on the left of the time in the display
Set the MIN and HOUR you want the set up to be turned on
Hit PROG again.
To set the time off, hit the same section, for example HQI three times, The arrow below the time will now point at AUTO again
Hit PROG
Hit the HQI button again until you see OFF shown on the left of the time in the display
Set the MIN and HOUR you want the set up to be turned off
Hit PROG
Repeat above on other sections.
this is off a piece of paper they gave me, hope this helps
Stripergod at hotmail dot c o m
Was this review helpful to you? 
|
|
 |
|
 |
|
Holy Cow 
